Snow Angels

For this project all you need is some pearls, white cloth stem or floral wire, ribbon (I used 1/8") , paper clips, and a few minutes.

The white wire that I used was very thin a 26 or 28 gauge I'm not sure because I tossed out the label.

Start with your wire and add a pearl to it. Make a loop and twist it back down, cut and bring your pearl back up and over the wire to cover it. Place the pearl onto your paper clip and thread your wire (see pic) through the center of the clip and back up to the top. Wrap it a few times to secure the bead.

Now using you ribbon from the front place one end into the "wings" of each side. Take the ribbon from the back and slide the ribbon down the sides of the bead toward the front of your project. Take the ends of the ribbons back through the wings and make a knot in the back of the angel. Your white wire should now be covered and you angel should hang straight and not forward. That's it, congrats you just made an angel.